Armor Tips

General Tips

Sizing and Fitting

• It cannot be stressed enough: Get used to wearing your armor BEFORE your first fight. You should NOT be pointing and fiddling with armor on the day of your first fight.
• This goes for any new piece of modification as well.
• Do a shakedown a week in advance of any fight if you can. Repeat the day before.
  1. Check your weapon(s)
  2. Armor up.
  3. Walk around.
  4. Hit a pell a few times.
• Make sure you can armor up and armor down with minimal help. Sometimes squires are scarce. Plan ahead.

Arming Points tips

• Some people (Jaye) like to use paracord with the core removed.
• Some people (Brian Chabot) like to use full core paracord with melted ends.
• Brian Chabot also likes to use 4mm tarred hemp marline with brass aiglets from The Practical Goose (at Pennsic)
• Many people like heavy leather lacing
• In the fabric of your arming clothes, *work* the holes rather than punching them. Use an awl or other tapered tool like a marlin spike to work the fibers apart. Brian Chabot thinks Sewn eyelets are pretty solid, but most ACL fighters sew a leather patch and punch holes in that for the lacing points. If you need patches, Nadler Metalcrafts carries them.

Anti-Rust Tips

• Jaye recommends 3-in-1 machine oil.
• WD-40 is NOT recommended as it will evaporate. You can use it to repel water, but it isn't good for storage.
• Brian Chabot recommends Fluid Film as it is lanolin based and good for both steel and leather
• A historical method is a mix of olive oil and bees wax. Wipe it on and polish like a car wax. This is available from Darkwood Armory under the brand of "Max Wax"